Equipment

Pressure-decay apparatus

The pressure-decay apparatus is used to study the diffusion of penetrants in polymers. The pressure-decay method studies the diffusion dynamics based on the response of a polymer sample to step changes of pressure and subsequent dynamics of pressure evolution caused by sorption or desorption processes. The pressure-decay apparatus (Figure 1) is composed of a measuring cell, heated cell, temperature and pressure measurement system and an industrial computer for data acquisition. The apparatus is designed for temperatures up to 200°C and pressures up to 30 bar. The polymer sample is placed in the measuring cell, which is positioned inside the heated cell and connected to inlet/outlet capillaries. The capillary system is equipped with an automatic valve, which enables the realization of well defined pressure steps. 

 

Two types of experiment can be carried out in the pressure-decay device: (i) stepwise pressure increase (sorption experiment) and (ii) stepwise pressure decrease (desorption experiment). These experiments are usually carried out subsequently, i.e., the sample is subjected to one or more stepwise pressure increases and then to one or more stepwise pressure decreases. 

Stepwise pressure increase: At the beginning of the experiment, the measuring cell is heated to the desired temperature and evacuated (pmin = 0). The gas is then introduced into the measuring cell. Immediately after the pressure-step, the pressure in the measurement cell is at maximum (pmax) and then gradually decreases (Figure 2) as the gas sorbs into the polymer until it reaches an equilibrium value (peq). The pressure step up is thus used to measure sorption into the polymer.

 

Stepwise pressure decrease: In this type of experiment, the measuring cell already contains the penetrant (pmax) and equilibrium is established. The pressure is then released. Immediately after the step, the pressure is at minimum (pmin) and then gradually increases as the penetrant desorbs from the polymer (Figure 3) until a new equilibrium is established (peq). The pressure step down is thus used to measure polymer desorption from the polymer.

 

 

 

In our laboratory, the pressure-decay apparatus is used to study the diffusion of various penetrants in polyethylene films and melts [odkaz]. 

 

Responsible persons:

 

 

Contact

Juraj Kosek
This email address is being protected from spambots. You need JavaScript enabled to view it.
+420 220 443 296

University of Chemistry and Technology Prague
Department of Chemical Engineering
Technicka 5
166 28 Prague 6
Czech Republic

University of West Bohemia
New Technologies Research Centre (NTC)
Univerzitní 8
306 14 Pilsen
Czech Republic