Equipment

Spinodal Decomposition

The spinodal decomposition apparatus was built in our laboratory for foaming the polymers via spinodal decomposition method. Mostly the open-cell microfoams are prepared by this method. The apparatus (Figure 1a and 1b) consists of a stainless steel vessel (D) with a thread for screwing on to the stainless steel top (A) and with a flange to attach to the bottom. Between the top and the bottom of the vessel two O-rings are placed (C, E) to ensure a sufficient sealing. The bottom of the mould (F) is from the copper sheet. As additional insulation can be used a Teflon cylinder (B). This arrangement enables the heat transfer to be one-dimensional.

 

 

Responsible persons:

 

Related topics:

Contact

Juraj Kosek
This email address is being protected from spambots. You need JavaScript enabled to view it.
+420 220 443 296

University of Chemistry and Technology Prague
Department of Chemical Engineering
Technicka 5
166 28 Prague 6
Czech Republic

University of West Bohemia
New Technologies Research Centre (NTC)
Univerzitní 8
306 14 Pilsen
Czech Republic